L298 Motor shield Mini with connector

Features:
Supply voltage 2V ~ 10V, can drive two DC motors or a 4-wire 2-phase stepper motors.
It can achieve forward rotation or reverse rotation. It is possible to adjust the rotation speed.
Each can provide continuous current of 1.5A, peak current up to 2.5A.
Built in thermal protection circuit if stalled due to temreature will do automatic recovery after the temperature drop.

Product Highlights:
Use of imported original chip, built-in low on-resistance MOS switch.
Minimal heat, no heat sink, small size, low power consumption, is ideal for battery powered.
(Much better than bulky L298N internal transistor switch which is low efficiency, high heat that requires heat sink, bulky, L298N very easy to burn).

Product parameters:
The module supply voltage 2V-10V.
Signal input voltage 1.8-7V.
Single Operating current 1.5A, peak current up to 2.5A, low standby current (less than 0.1uA).
Built-in common conduction circuit, when the input pin is left floating, the motor does not malfunction.
Built-in thermal protection circuit with hysteresis effects (TSD), without worrying about motor stall.
Product Size: 24.7 * 21 * 5mm (length, width, height), ultra-small size. The mounting hole diameter: 2 mm.

Precautions:
Power positive and negative reversed will certainly cause damage to the circuit.
Giving excess current and volage than the rated may lead to circuit burn.